100	Unknown flag : %s\n
101	Usage : OS2 /P <full path> /C <original CommandLine>\n
102	Command missing from syntax\nUsage : OS2 /P <full path> /C <original CommandLine>\n
103	Cannot connect to OS2 SubSystem\n
104	Cannot Start Process\n
105	Cannot Create CONOUT\n
106	Cannot Create Thread \n
200	Error Init routine failed\n
201	Error invalid segment number\n
202	Error module marked invalid\n
203	The file %s has an invalid stack address\n
204	The system cannot find the file %s\n
205	Error procedure not found %s\n
206	Error ordinal not found %s\n
207	The file %s has an invalid starting address\n
208	The module %s has an invalid module type\n
209	The file %s has a bad executable format\n
210	Insufficient Memory\n
211	Relocation Chain Exceeds Limit\n
212	Error OS/2 error code %s\n
213	The file %s has a bad format\n
300	OS/2 Subsystem -- CONFIG.SYS Access
301	An OS/2 Application requested access to CONFIG.SYS - Read Only access is granted. In order to modify OS/2 CONFIG.SYS, logon as ADMINISTRATOR.\n
302	%s.EXE - Write Protect Error
303	The disk cannot be written to because it is write protected.\nPlease remove the write protection from the volume\nin drive%s.\n
304	%s.EXE - No Disk
305	There is no disk in the drive.\nPlease insert a disk into drive%s.\n
306	Internal OS/2 Subsystem Error - application terminated
307	%s - OS/2 Subsystem Bound Application Load Failure
308	You are attempting to execute a bound DOS - OS/2 application. This application uses an unsupported OS/2 API, and therefore cannot be executed by the OS/2 Subsystem. After the application terminates, you may try re-running it using forcedos, as the DOS Subsystem may be able to support it. Press Enter to terminate the application.